Skip to content
DoorsEZDoorsEZBook online
DoorsEZDoorsEZ

Symptom: spring trouble

Signs of a broken or failing garage door spring

Springs lift most of your door's weight, so a failing spring usually shows in how the door moves before it ends with a bang. Here is what to look and listen for from a safe distance, one check that is safe when the springs look whole, and what to leave to us.

Inside view of a white garage door with stained-glass windows and a rusty torsion spring on the shaft above.
  • Open 24/7 ยท a person answers

    Same-day on most repairs booked by 11 am.

  • Callback within 15 minutes

    Day or night, every day.

  • Written price first

    Nothing starts until you approve it.

  • CSLB Lic. #859029

    C-61 / D-28 ยท Verify on the CSLB website (opens in a new tab)

The short answer

The short answer

A broken torsion spring shows a gap of a few inches in its coil; a broken extension spring hangs loose or stretched. Before a spring breaks, watch for a door that feels heavy, drifts when stopped halfway, rises crooked, or springs with rust on the coils. Look, do not touch, and call DoorsEZ at (833) 366-7739.

Safety first

Look, do not touch. Do not adjust, wind, unwind or remove a spring, and do not loosen the cables or the bottom brackets. They hold the stored tension that lifts the door, and that tension can release suddenly and cause serious injury. Do not climb a ladder next to a spring to look closer. If a spring is broken, keep the door closed, unplug the opener and do not pull the emergency release while the door is open, because the door can drop fast.

What you might notice

  • A gap of a few inches in a coiled spring on the bar above the door
  • An extension spring that hangs loose, has snapped, or stays stretched with the door open
  • Rust or flaking on the spring coils
  • The door feels heavier than it used to when lifted by hand
  • The door drifts down or pulls up when stopped halfway with the opener disconnected
  • The door rises unevenly, or the opener strains, slows or stops partway
  • Squeaking or creaking from the spring itself as the door moves

What you get

What the work includes

  • Inspection of torsion or extension springs, cables, drums, pulleys and bearings
  • Balance check with the opener disconnected
  • Measurement of the springs and the door, so a replacement matches the door as it is today
  • A written price for replacing one spring and for replacing both on two-spring doors
  • Lubrication of springs, hinges and rollers
  • Opener force and travel check, then the reverse test after opener work (HSC section 19890)

How it works

From your call to a working door

  1. Look from the floor

    Stand to the side of the door, not under it, and look at the springs above the door or along the tracks. Take a photo; do not touch.

  2. Watch the door move

    Run the door once and watch for a crooked rise, jerky movement, or an opener that strains or stops. If anything looks wrong, stop running it and unplug the opener.

  3. Book or call

    Book online or call (833) 366-7739. We call back within 15 minutes, day or night, and the dispatcher confirms a time window. Send the photo if you can; it helps us bring the right springs.

  4. Inspect, price, replace

    The technician measures the springs and the door, explains what is worn and writes the price down. Nothing starts until you approve. After the work we check the balance and, if we touched the opener, run the reverse test.

Details

What a broken spring looks like

Your door uses one of two spring types, and each fails in its own way.

Torsion springs sit on a steel bar just above the door opening. They are wound tight, coil against coil. When one breaks, it unwinds and leaves a clear gap of a few inches somewhere along its length. On a two-spring door only one may have broken, so check both.

Extension springs run above the horizontal tracks on each side of the door and stretch as the door closes. A broken one may hang down, lie on the track or have snapped at one end. Each should have a safety cable running through its center to hold the pieces if it breaks. If yours have none, tell us when you book.

A broken spring often announces itself with a loud bang, sometimes when nobody was using the door. Springs are under the most tension when the door is closed, so they can fail while the door sits shut. After that, the opener may hum, lift the door a few inches and stop, or the door feels far heavier than it should. Any of these means the door should stay closed until the spring is replaced; our broken spring page explains the repair.

Warning signs before a spring breaks

Springs wear a little with every cycle, one opening and one closing, and they often give some warning first. Watch for these:

  1. The door feels heavier. If you lift it by hand during an outage and it takes more effort than it used to, the springs are carrying less of the weight.
  2. Rust on the coils. Rust adds friction each time the coils wind and unwind, and it can weaken the steel. Salt air near the coast makes it more common.
  3. Uneven lift. One side of the door rises before the other, or the door jerks as it moves.
  4. Noise from the spring. Squeaks or creaks from the coils themselves, rather than from the rollers or hinges.
  5. The opener struggles. It slows, strains or stops on the way up, on a door that used to run smoothly.

For example, say a Garden Grove homeowner notices the opener sounds louder on the way up and the door now lifts a little crooked. From the floor, the torsion spring looks rust-brown. Nothing has broken yet, and that is the right moment to book an inspection, before the spring fails with the car inside.

A balance check that is safe when the springs look whole

This check tells you whether the springs are still carrying the door. Many opener manuals describe it. Do it only when the door is fully closed, the springs show no gap, and both cables are tight.

  1. With the door fully closed, pull the red emergency release so the door is disconnected from the opener.
  2. Stand to the side, hold the door by a handle or the bottom section, and lift it by hand to about halfway.
  3. Let go gently, keeping your hands ready and your feet clear.

A balanced door stays put or moves only slightly. A door that drifts down, drops, or pulls itself upward has springs that are worn, broken or set wrong. Lower it gently to the floor and stop there. Do not try to correct the tension yourself: spring tension is set with winding bars while the spring holds the door's weight, and a slip can cause serious injury.

When you are done, reconnect the opener the way your manual describes. If the door failed the check, book a spring inspection, and mention it when you call. Our maintenance inspection includes the same check, done by a technician.

Price

What affects the cost

Replacing a worn spring on a planned visit avoids a door stuck shut and the strain a broken spring puts on the opener. The written price depends on the spring type, how many springs the door uses, its size and weight, and whether the cables, drums or bearings are also worn. The technician writes the full price down, including every mandatory fee, and nothing starts until you approve it.

How our pricing works

Questions

Spring warning signs questions

Still unsure? Call (833) 366-7739 and talk to a person.

How do I know if my garage door spring is broken?

Look at the spring from the floor. A torsion spring above the door shows a gap of a few inches in its coil; an extension spring along the track hangs loose or has snapped. A loud bang, a very heavy door, or an opener that lifts the door a few inches and stops are other signs.

Can I still open the door with a broken spring?

Do not try. The springs carry most of the door's weight; without them the door is heavy and can fall, and the opener can be damaged lifting it. Keep the door closed, unplug the opener and call (833) 366-7739.

Is it a problem if my springs are rusty?

Rust does not always mean a spring is about to break, but it adds friction and can weaken the steel. If the door also feels heavy or lifts unevenly, book an inspection. The technician tells you what is worn and writes a price before any work starts.

Should I replace a spring before it breaks?

If the balance check fails or a spring is visibly worn, a planned replacement avoids a door stuck shut with the car inside. On a two-spring door we write a price for one spring and for both, explain the trade-off, and you choose.

Open 24/7 ยท a person answers

Talk to a person today

Book online or call (833) 366-7739. We call back within 15 minutes, day or night.